Using a Waterproof Rain Test Chamber to Ensure Durability and Reliability

Waterproof Rain Test Chamber is an advanced device used to simulate atmospheric environment, so the safe use and correct operation of it is very important. So, what should we pay attention to in order to ensure the safe and reliable operation of Waterproof Rain Test Chamber? What are the operation specifications of LISUN’s Waterproof Rain Test Chamber? Here we take the LISUN Waterproof Rain Test Chamber as an example to introduce the “attention and operation specifications of Rainfall Test Box”.

waterproof test Equipment JL-X

I. Attention about Waterproof Rain Test Chamber:
1. In use, if unusual sound occurs, the machine should be stopped for inspection to find out the reason before restarting to avoid delay or damage to the equipment.
2. The transmission mechanism should be refueled regularly, and 20 clean oil should be added to the reducer and transmission components.
3. When placing Waterproof Rain Test Chamber, the bracket should be raised to avoid shifting during testing due to external vibration.
4. If it is found that the water jet hole is blocked after long-term use, the pipeline should be dismantled, flushed with tap water, and then assembled back.

II. Operation Specifications of Waterproof Rain Test Chamber:
1. After turning on the power supply, the machine will stop running after running according to the set control program.
2. When placing the test sample, pay attention to the capacity should not exceed 2/3 of the test area capacity.
3. According to the operation manual, first test settings, and then according to the set operating mode into the test state.
4. You can open the door light to see the temperature and humidity changes in the box (if no humidity requirement is tested, the humidity data will not be displayed), and observe the test state.
5. After taking out the test sample, record the test situation, and then turn off the power switch.

Above are the attention items and operation specifications of Waterproof Rain Test Chamber for safe and reliable operation. With the correct implementation of LISUN Waterproof Rain Test Chamber operation regulations, an effective and reliable guarantee can be provided for the test. In addition, in order to ensure the normal operation of the equipment, Waterproof Rain Test Chamber also has the characteristics of its device installation site. There are the following requirements:
1. The site should reserve enough space to accommodate the equipment and leave the corresponding maintenance space;
2. The equipment should be equipped with a water inlet device with a water purification filter system;
3. To protect the equipment, it should be equipped with good grounding facilities, and waterproof bases and covers are installed;
4. The height of the site space should be able to make the equipment run normally and be able to maintain and repair;
5. The annual temperature should be kept between 5-40℃, the relative humidity should be less than 85%, and good ventilation facilities should be provided;
6. The installation site should avoid dust as much as possible;
7. The environmental temperature of the installation site must not suddenly change;
8. It should be installed on a level ground and confirmed by a level meter;
9. The installation site should not be exposed to direct sunlight;
10. It should be far away from combustible, explosive and high temperature heat sources.

Lisun Instruments Limited was found by LISUN GROUP in 2003. LISUN quality system has been strictly certified by ISO9001:2015. As a CIE Membership, LISUN products are designed based on CIE, IEC and other international or national standards. All products passed CE certificate and authenticated by the third party lab.

Our main products are Goniophotometer, Integrating Sphere, Spectroradiometer, Surge Generator, ESD Simulator Guns, EMI Receiver, EMC Test Equipment, Electrical Safety Tester, Environmental Chamber, Temperature Chamber, Climate Chamber, Thermal Chamber, Salt Spray Test, Dust Test Chamber, Waterproof Test, RoHS Test (EDXRF), Glow Wire Test and Needle Flame Test.

Please feel free to contact us if you need any support.
Tech Dep: Service@Lisungroup.com, Cell/WhatsApp:+8615317907381
Sales Dep: Sales@Lisungroup.com, Cell/WhatsApp:+8618117273997