IS 16102-1 Self-Ballasted LED Lamps for General Lighting Services Part 1 Safety Requirements

This Indian Standard IS 16102 (Part 1) was adopted by the Bureau of Indian Standards, after the draft finalized by the Electric Lamps and Their Auxiliaries Sectional Committee had been approved by the Electrotechnical Division Council.

This standard IS 16102 specifies the general and safety requirements for self-ballasted lamps for general lighting services for d.c. supplies up to 250 V or a.c. supplies up to 1 000 Vat 50 Hz.

The performance requirements have been covered in Part 2 of this standard.

This standard is published in two parts. The other part in the series is:

Part 2Performance requirements

There are already LED products in the market which substitute existing lamps, either as retrofit mains voltage incandescent or self-ballasted fluorescent lamps or as replacement for tungsten halogen lamps below 50 V.

Future work will also consequently comprise performance standards for all kind of LED lamps, including minimum photometric requirements for type testing.

This standard IS 16102 is based on IEC 62560:2011‘Self-ballasted LED lamps for general lighting services by voltage above 50V – Safety specifications’, issued by the International Electrotechnical Commission (IEC) with the following modifications:
a) Made applicable for d.c. supplies up to 250V or a.c. supplies up to 1 000 V at 50 Hz;
b) Schedule of type test and acceptance test has been incorporated;
c) Selection of samples incorporated;
d) Conditions of compliances incorporated; and
e)Marking of rated lumen and danger symbol on high temperature added.

For the purpose of deciding whether a particular requirement of this standard is complied with, the final value, observed or calculated expressing the result of a test or analysis, shall be rounded off in accordance with IS 2: 1960 ‘Rules for rounding off numerical values (revised)’. The number of significant places retained in the rounded off value should be the same as that of the specified value in this standard

IS 16102-1:2012 Self-Ballasted LED Lamps for General Lighting Services Part 1 Safety Requirements

SMT-02T10 IEC 61032 Standard Articulated Test Probe with 10N Thrust

WB2681A Insulation Resistance Tester

LSP-500VARC Pure Sine Wave AC Power Source (High Precision)

CH338 Digital Torsion Meter

ZBP-T Ball Pressure Test Device

GDJS-015B Temperature Humidity Chamber | Thermal Chamber

ZY-3 Needle Flame Test