IS 15885 (Part 1): 2011 Safety Of Lamp Controlgear Part 1 General Requirements

FOREWORD
This Indian Standard IS 15885 (Part 1): 2011 was adopted by the Bureau of Indian Standards, after the draft finalized by the Electric Lamps and Their Auxiliaries Sectional Committee had been approved by the Electrotechnical Division Council.

This standard IS 15885 (Part 1): 2011 is published in two parts. The other part and sections are:
Part 2   Particular requirements
Section 1   Starting devices (other than glow starters)
Section 2   dc or ac supplied electronic step-down convertors for filament lamps
Section 3   ac supplied electronic ballasts for fluorescent lamps
Section 4   dc electronic ballast for general lighting
Section 5   dc supplied electronic ballast for public transport system
Section 6   dc supplied electronic ballast for aircraft lighting
Section 7   dc supplied electronic ballast for emergency lighting
Section 8   Ballasts for fluorescent lamps
Section 9   Ballasts for discharge lamps (excluding fluorescent lamps)
Section 10   Electronic invertors and convertors for high frequency operation of cold start tubular discharge lamps (neon tubes)
Section 11   Miscellaneous electronic circuits used with luminaires.

Formulation of standards in respect of (Part 2/Sec2), (Part 2/Sec 4), (Part 2/Sec 6), (Part 2/Sec 7), (Part 2/Sec 10) and (Part 2/Sec 11) shall be taken up at a later date as when need arises.

This standard IS 15885 (Part 1): 2011 provides as set of general and safety requirements and tests which are considered to be generally applicable to most types of lamp controlgear and which can be called up as required by the appropriate Part 2 of this standard. This standard is thus not to be regarded as a specification in itself for any type of lamp controlgear, and its provisions apply only to particular types of lamp controlgear, to the extent determined by the appropriate Part 2 of this standard.

The formatting into separately published parts provides for ease of future amendments and revisions. Additional requirements will be added as and when a need for them is recognized.

IS 15885 (Part 1): 2011 Safety Of Lamp Controlgear Part 1 General Requirements

LISUN supplies the fully test solutions for the following IS 15885 (Part 1): 2011, please see the below excel table:

WT5000 Electronic Ballast Tester

LSP-500VARC Pure Sine Wave AC Power Source (High Precision)

LEDLM-84PL LED Optical Aging Test Instrument

GDJS-015B Temperature Humidity Chamber | Thermal Chamber

WB2681A Insulation Resistance Tester

HF2686C Electrolytic Capacitor Tester

CK-1 Creepage Clearances Distance Gauge | Creepage Distance Test Cards

ZRS-3H Glow-wire Test Apparatus

ZY-3 Needle Flame Test

TTC-1 Tracking Test Chamber | Leakage Tracking Test Apparatus

YWX/Q-010 Salt Spray Test | Salt Spray Test Chamber