How does a salt fog chamber work

Metal components, zinc plated nuts and bolts, surface coatings, and paint may be tested for corrosion resistance in salt spray test chambers or salt fog chambers. It is possible to test the suitability of a layer for use as a protective finish on finished items in such chambers, where coated samples are placed in a simulated corrosion environment. Corrosion-resistant samples are tested for a certain period; the longer the test time, the more corrosion-resistant the sample.

Products, materials, and components exposed to the elements must be able to survive corrosion. A high level of salt spray and fog resistance is necessary to meet legal requirements and provide a higher-quality product to your customers and other stakeholders.

Protective finishes and coatings and salt deposits’ physical and electrical impacts on a product are subjected to Salt-fog or Salt Spray testing to verify their efficacy.

Working of salt fog chamber
To know the working of the salt fog chamber, you must know the construction of this chamber.

Construction
Salt fog chambers’ inner and outer walls are constructed with a double-wall design that allows warm air to circulate between them. Warm air is distributed in a closed-loop by blowers and heaters at the unit’s foundation.

To create the salt environment, the atomizing nozzle draws salt solution from the reservoir with compressed air. The hot water kept in the saturation tower is used to warm and saturate the compressed air. You can get the best salt fog chamber from the LISUN.

salt spray test chambers

A small quantity of condensing moisture continually purges the nozzle, lessening the likelihood for the salt solution to crystallize and clog by saturating the air at a temperature higher than that near the salt spray nozzle. Consistent conditions are maintained at the nozzle, resulting in a uniform environment in the test chamber.

You should prepare the salt solution in line with the test requirements. If you’re using distilled or demineralized water, you’ll need to add two pounds of sodium chloride to every gallon of water.

You may adjust the thermostat by rotating the adjustment screw if it is required to alter the temperature. The temperature is lower when the screw is turned clockwise. You should make adjustments in eighth-turn increments. Before making any more modifications, be sure to provide sufficient time for stability.

Working
The working procedure is as follows:
1. Keep the chamber on a flat surface before starting the experiment.
2. Ensure that the vent line is clear of obstructions before connecting it.
3. Fill the reservoir of the tower.
4. Ensure that the salt reservoir is filled to within an inch of the top before reinstalling the lid.
5. Close the top cover trough when you’ve finished filling it.
6. Connect the compressed air source to the chamber.
7. Open the air valve in the chamber.
8. You should turn
on compressed air.
9. Put the tower switch in the “on” position with the selection valve in the “salt spray” position.
10. Observe the pilot lights on the electric panel to ensure that the thermostats are operating correctly.

Lisun Instruments Limited was found by LISUN GROUP in 2003. LISUN quality system has been strictly certified by ISO9001:2015. As a CIE Membership, LISUN products are designed based on CIE, IEC and other international or national standards. All products passed CE certificate and authenticated by the third party lab.

Our main products are Goniophotometer, Integrating Sphere, Spectroradiometer, Surge Generator, ESD Simulator Guns, EMI Receiver, EMC Test Equipment, Electrical Safety Tester, Environmental Chamber, Temperature Chamber, Climate Chamber, Thermal Chamber, Salt Spray Test, Dust Test Chamber, Waterproof Test, RoHS Test (EDXRF), Glow Wire Test and Needle Flame Test.

Please feel free to contact us if you need any support.
Tech Dep: Service@Lisungroup.com, Cell/WhatsApp:+8615317907381
Sales Dep: Sales@Lisungroup.com, Cell/WhatsApp:+8618117273997