Test Pin UL 60950-1 Figure2B S2962D

1 General

1.1 Scope

1.1.1 Equipment covered by this standard

This standard is applicable to mains-powered or battery-powered information technology equipment, including electrical business equipment and associated equipment, with a RATED VOLTAGE not exceeding 600 V and designed to be installed in accordance with the Canadian Electrical Code.Part1.CSA C22.1 12:General Requirements-Canadian ElectricalCode.Part 11.CSA C22.2 No.0-10:the National Electrical Code.NFPA 70-2014: and the National Electrical Safety Code,IEEE C2-2012.

The standard is also applicable to equipment. unless otherwise identified by a marking or instructions. designed to be installed in accordance with Article 645 of the NationalElectrical Code.ANSI/NFPA 70. and the Standard for the Protection of Information Technology Equipment.NFPA 75-2013.

See Annex NAE for examples of and references to regulatory requirements that apply to this equipment.

This standard is also applicable to such information technology equipment:

– designed for use as telecommunication terminal equipment and TELECOMMUNICATION NETWORK infrastructure equipment, regardless of the source of power;
– designed and intended to be connected directly to, or used as infrastructure equipment in, a CABLE DISTRIBUTION SYSTEM,regardless of the source of power;
– designed to use the ACMAINS SUPPLY as a communication transmission medium (see Clause 6, Note 4 and 7.1, Note 4).

This part of UL 60950 is also applicable to:

– components and subassemblies intended for incorporation in this equipment. Such components and subassemblies need not comply with every requirement of the standard, provided that the complete equipment, incorporating such components and subassemblies, does comply;
– external power supply units intended to supply other equipment within the scope of this part of UL 60950;
– accessories intended to be used with equipment within the scope of this part of UL 60950.

SMT 1213_AL

NOTE 1 Examples of aspects with which uninstalled components, subassemblies, and accessories may not comply include the marking of the power rating and access to hazardous parts.

NOTE 2 This standard may be applied to the electronic parts of equipment even if that equipment does not wholly fall within its Scope, such as large-scale air conditioning systems, fire detection systems and fire extinguishing systems. Different requirements may be necessary for some applications.

This standard specifies requirements intended to reduce risks of fire, electric shock or injury for the OPERATOR and layman who may come into contact with the equipment and, where specifically stated, for a SERVICE PERSON.

Meets UL 60950-1

This UL 60950-1 Figure 2B Test Pin S2962D is intended to verify the protection against access to hazardous live parts in class 0 equipment and class II equipment (see IEC60536).
Conforms to: Standard UL 60950-1 etc.
Technical Parameter:
Test probe diameter: 3 mm
Test probe length: 15 mm
Baffle plate thickness: 4 mm
Baffle plate diameter: 25 mm
Handle length: 20 mm
Handle diameter: 10 mm