IEC 60745-2-11 Hand-held motor-operated electric tools – Safety -Part 2-11: Particular requirements for reciprocating saws (jig and sabre saws)

Scope

This clause of Part 1 is applicable, except as follows:

Addition:
This standard applies to reciprocating saws such as jig saws and sabre saws.

Normative references

This clause of Part 1 is applicable.

Terms and definitions

This clause of Part 1 is applicable, except as follows:

Additional definitions:

reciprocating saw:
tool intended for cutting various material with a blade or blades acting in a reciprocating or
oscillating motion

jigsaw: reciprocating saw with a base plate that may allow bevel adjustments

NOTE Typical designs of jigsaws are shown in Figure 102.

sabre saw: reciprocating saw with a guide plate that may allow tilting movements

NOTE Typical designs of sabre saws are shown in Figure 103.

General requirements

This clause of Part 1 is applicable.

General conditions for the tests

This clause of Part 1 is applicable.

LISUN following instruments fully meet IEC 60745-2-11 Hand-held motor-operated electric tools – Safety -Part 2-11: Particular requirements for reciprocating saws (jig and sabre saws)

ZRS-3H Glow-wire Test Apparatus

GDJS-015B Temperature Humidity Chamber | Thermal Chamber

LS9955 Automatic Safety Test System

ESD61000-2 ESD Simulator Guns

EFT61000-4 EFT Immunity Measurement

SW-6 IEC 60884-1 Clause 23.4 | IEC 60745-1 Clause 24.12 | IEC 60335-1 Clause 25.14 Power Cord Flexibility Bending Tester

JL-X IP Waterproof Test Equipments

IK01-07 Spring Impact Hammer IK Level Tester IEC 60068-2-75

ZY-3 Needle Flame Test

TTC-1 Tracking Test Chamber | Leakage Tracking Test Apparatus