IEC 62052-31:2024 Electricity metering equipment – General requirements, tests and test conditions – Part 31: Product safety requirements and tests

IEC 62052 – 31:2024 is a standard about electricity metering equipment formulated by the International Electrotechnical Commission (IEC). It specifies general safety requirements and associated tests, along with their appropriate conditions for type testing of directly connected, transformer – operated or transducer – operated AC and DC electricity meters and load control equipment.

This standard applies to electricity metering equipment designed to measure and control electrical energy on electrical networks with voltage up to 1,000 V AC, or 1,500 V DC. The safety requirements are based on the assumptions that the metering equipment is correctly installed and used by ordinary persons. It also covers various aspects such as electrical safety, mechanical safety, and environmental adaptability, aiming to ensure the safe and reliable operation of electricity metering equipment in use.

LISUN supplies the fully test solutions for the following IEC 62052-31:2024, please see the below excel table:

IEC 62052-31:2024 Clause and Subject	LISUN MODEL
4.3.1 Atmospheric conditions	GDJS-015B
10.4 Temperature test
6.2.2 Test probe B&test probe 11	SMT-PB&SMT-1150
6.4.3 Basic insulation	WB2681A
6.4.4 Impedance	LS90
6.7.2.3 Creepage distances	CK-1
6.9.3.1 Impulse voltage test	SUG255
6.9.3.2 Surge test	SG61000-5
6.9.3.4 DC voltage test	DC3005
8.2 Spring hammer test	IK01-07
9.3.2.1 glow-wire test	ZRS-3H
9.3.2.3 vertical burning test	HVR-LS
10.5 Resistance to heat	ZBP-T
	GW-500
11 Protection against penetration of dust and water	SC-015
	JL-X

Tags：CK-1 , DC3005 , GDJS-015B , HVR-LS , IK01-07 , JL-X , LS90 , SC-015 , SG61000-5 , SMT-1150 , SMT-PB , SUG255 , WB2681A , ZBP-T , ZRS-3H